SPEED SENSOR

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during transmission revolution sensor removal/installation are shown below.

Note:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click here

Table 1. Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Auxiliary battery terminal is disconnected/reconnected	Memorize steering angle neutral point	LKA/LDA system (for Mono camera type)	for Stereo Camera type:Click here for Mono Camera type:Click here
		Lane control system (for Stereo camera type)
		Parking support brake system*1
		Pre-collision system (for Stereo camera type)
		Pre-collision system (for Mono camera type)
		Adaptive high beam system
		Lighting system (EXT) Cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic view monitor system	Click here
	Initialize rear door sunshade system	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here
Air leaks from intake system Gas leak from exhaust system is repaired	Inspection after repair	Poor idle, etc. Engine start function, etc.	w/ Canister Pump Module:Click here w/o Canister Pump Module:Click here
Suspension, tires, etc	Ultrasonic sensor detection angle Ultrasonic sensor detection angle registration	Parking support brake system	Click here
	Parking assist ECU initialization Adjust steering angle Rear television camera view adjustment (for Rear camera detection system)	Panoramic view monitor system	Click here
	Rear television camera assembly optical axis (Back camera position setting)	Parking assist monitor system	Click here
Front bumper assembly (Including removal and installation)	Ultrasonic sensor detection angle Ultrasonic sensor detection angle registration	Parking support brake system	Click here
Front bumper assembly (Including removal and installation)	Front television camera view adjustment	Panoramic view monitor system	Click here

*1: When performing learning using the GTS. Click hereClick here

CAUTION:

Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.
Click here
To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
*a An Object Exceeding Weight Limit of Engine Lifter

The engine assembly with hybrid vehicle transmission assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the engine lifter may suddenly drop or the engine assembly with hybrid vehicle transmission assembly may fall off the engine lifter.
*a Object Exceeding Weight Limit of Transmission Jack

The hybrid vehicle transmission assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the transmission jack may suddenly drop or a part may fall.

Note:

After the power switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the power switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click here

PROCEDURE

Click here
ADJUST STANDARD VEHICLE HEIGHT (w/ Air Suspension)

Click here
Click here
REMOVE ENGINE ASSEMBLY WITH HYBRID VEHICLE TRANSMISSION

Click here
Click here
REMOVE TRANSMISSION REVOLUTION SENSOR
1. Disconnect the transmission revolution sensor connector.
2. Remove the bolt and the transmission revolution sensor.
3. Remove the O-ring from the transmission revolution sensor.

SPEED SENSOR REMOVAL