PTC HEATER ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the PTC heater assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA System

Click here

Pre-crash safety system

Lighting system (EXT)


  • Cornering lights
Adaptive high beam system
Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Parking assist monitor system (w/ Parallel parking assist function)

Click here

Parking assist monitor system (w/o Parallel parking assist function)

Click here

Panoramic view monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Reset back door close position Power back door system

Click here

PROCEDURE


  1. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  2. REMOVE CONSOLE BOX ASSEMBLY

    Click here

  3. REMOVE FRONT NO. 1 CONSOLE BOX INSERT

    Click here

  4. REMOVE NO. 4 AIR DUCT SUB-ASSEMBLY

    Click here

  5. REMOVE NO. 2 HEATER COVER


    1. B005P75

      Remove the screw.

    2. Disengage the claw and guide to remove the No. 2 heater cover.

  6. REMOVE QUICK HEATER ASSEMBLY


    1. B005MEL

      Disconnect the 2 connectors.

    2. B005O80C01
      B005OOA Remove in this Direction

      Disengage the guide and remove the quick heater assembly as shown in the illustration.