CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the lower No. 1 instrument panel airbag assembly removal/installation are shown below.
Replacement Part or Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
---|---|---|---|
Disconnect cable from negative battery terminal | Memorize steering angle neutral point | LKA/LDA System | |
Pre-crash safety system | |||
Lighting system (EXT)
|
|||
Adaptive high beam system | |||
Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) | Stop and start system | ||
Memorize steering angle neutral point | Parking assist monitor system (w/ Parallel parking assist function) | ||
Parking assist monitor system (w/o Parallel parking assist function) | |||
Panoramic view monitor system | |||
Initialize back door lock | Power door lock control system | ||
Reset back door close position | Power back door system |
Tech Tips
Use the same procedure for RHD and LHD vehicles.
The following procedure is for an LHD vehicle.
PROCEDURE
PRECAUTION
Note
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
REMOVE FRONT DOOR SCUFF PLATE LH
REMOVE COWL SIDE TRIM BOARD LH
REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
REMOVE INSTRUMENT PANEL GARNISH LH
DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT
REMOVE LOWER INSTRUMENT FINISH PANEL SUB
REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
CAUTION:
When storing the lower No. 1 instrument panel airbag assembly, keep the airbag deployment side facing upward.
Deployment Side |
Check that the engine switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
*a | Hook |
*b | Guide |
Remove the 2 bolts.
Disengage the 3 claws, hook and 2 guides to separate the lower No. 1 instrument panel airbag assembly.
Note
When separating the lower No. 1 instrument panel airbag assembly, do not pull the airbag wire harness.
*a | Protective Tape |
*b | Airbag Connector |
*c | Airbag Connector Lock |
Using a screwdriver with its tip wrapped with protective tape, release the airbag connector lock.
Disconnect the airbag connector to remove the lower No. 1 instrument panel airbag assembly.
Note
When disconnecting any airbag connector, take care not to damage the airbag wire harness.