BRAKE PEDAL(for RHD) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during brake pedal removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Memorize steering angle neutral point LKA/LDA System

Click here

Pre-Crash Safety System

Lighting System (EXT)


  • Cornering lights
Adaptive High Beam System
Parking Assist Monitor System (w/ Parallel Parking Assist Function)

Click here

Parking Assist Monitor System (w/o Parallel Parking Assist Function)

Click here

Panoramic View Monitor System

Click here

Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and start system

Click here

Initialize back door lock Power door lock control system

Click here

Reset back door close position Power back door system

Click here

PROCEDURE


  1. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Tech Tips

    Use the same procedure as for LHD.

    Click here

  2. REMOVE STOP LIGHT SWITCH ASSEMBLY

    Click here

  3. REMOVE BRAKE PEDAL RETURN SPRING


    1. B005PC7

      Remove the brake pedal return spring from the instrument panel reinforcement assembly and push rod pin.

  4. REMOVE PUSH ROD PIN


    1. B005M44

      Remove the clip and push rod pin.

  5. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    1. B005NAR

      Disconnect the connector and disengage the clamp.

    2. B005NUL

      Remove the 2 bolts and separate the brake pedal support assembly from the instrument panel reinforcement assembly.

    3. B005LE3

      Remove the 4 nuts and brake pedal support assembly.