BRAKE PEDAL(for LHD) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during brake pedal removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Memorize steering angle neutral point LKA/LDA System

Click here

Pre-Crash Safety System

Lighting System (EXT)


  • Cornering lights
Adaptive High Beam System
Parking Assist Monitor System (w/ Parallel Parking Assist Function)

Click here

Parking Assist Monitor System (w/o Parallel Parking Assist Function)

Click here

Panoramic View Monitor System

Click here

Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and start system

Click here

Initialize back door lock Power door lock control system

Click here

Reset back door close position Power back door system

Click here

PROCEDURE


  1. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  2. REMOVE STOP LIGHT SWITCH ASSEMBLY

    Click here

  3. REMOVE BRAKE PEDAL RETURN SPRING


    1. B005MMR

      Remove the brake pedal return spring from the instrument panel reinforcement assembly and push rod pin.

  4. REMOVE PUSH ROD PIN


    1. B005LCY

      Remove the clip and push rod pin.

  5. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    1. B005O0J

      Disconnect the connector and disengage the clamp.

    2. B005NTA

      Remove the 2 bolts and separate the brake pedal support assembly from the instrument panel reinforcement assembly.

    3. B005O5X

      Remove the 4 nuts and brake pedal support assembly.