HEADLIGHT LEVELING ECU REMOVAL

PROCEDURE

1. PRECAUTION (for RHD)

   Note

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for RHD)

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

3. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

   Click here

4. REMOVE FRONT DOOR SCUFF PLATE

   Click here

5. REMOVE COWL SIDE TRIM BOARD

   Click here

6. REMOVE FRONT DOOR OPENING TRIM COVER

   Click here

7. REMOVE INSTRUMENT SIDE PANEL

   Click here

8. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   Click here

9. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

   Click here

10. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for RHD)

    Click here

11. REMOVE ECU INTEGRATION BOX RH (for RHD)

    Click here

12. REMOVE HEADLIGHT LEVELING ECU (HEADLIGHT SWIVEL ECU ASSEMBLY)

    
    

    1. 

       Disconnect the connector.

    2. Disengage the clamp.

    3. Remove the bolt and headlight leveling ECU (headlight swivel ECU assembly).