WIPER ECU REMOVAL

PROCEDURE

1. PRECAUTION

   Note

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

3. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

   Click here

4. REMOVE FRONT DOOR SCUFF PLATE RH

   Tech Tips

   Use the same procedure as for the LH side Click here.

5. REMOVE COWL SIDE TRIM BOARD RH

   Tech Tips

   Use the same procedure as for the LH side Click here.

6. REMOVE FRONT DOOR OPENING TRIM COVER RH

   Tech Tips

   Use the same procedure as for the LH side Click here.

7. REMOVE INSTRUMENT SIDE PANEL RH

   Click here

8. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

9. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

   Click here

10. REMOVE INSTRUMENT PANEL BOX DOOR COVER

    Click here

11. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

12. REMOVE WINDSHIELD WIPER RELAY ASSEMBLY

    
    

    1. 

       Remove the nut.

    2. Disconnect the connector and remove the windshield wiper relay assembly.