HOOD LOCK CONTROL CABLE ASSEMBLY REMOVAL

PROCEDURE


  1. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  2. REMOVE FRONT WHEEL LH (for LHD)

  3. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH (for LHD)

    Tech Tips

    Use the same procedure as for the RH side Click here.

  4. REMOVE FRONT FENDER LINER LH (for LHD)

    Tech Tips

    Use the same procedure as for the RH side Click here.

  5. REMOVE FRONT WHEEL RH (for RHD)

  6. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH (for RHD)

    Click here

  7. REMOVE FRONT FENDER LINER RH (for RHD)

    Click here

  8. REMOVE FRONT DOOR SCUFF PLATE LH (for LHD)

    Click here

  9. REMOVE COWL SIDE TRIM BOARD LH (for LHD)

    Click here

  10. REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)

    Tech Tips

    Use the same procedure as for the LH side Click here.

  11. REMOVE COWL SIDE TRIM BOARD RH (for RHD)

    Tech Tips

    Use the same procedure as for the LH side Click here.

  12. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

    Click here

  13. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. A01W3EP

      Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.

  14. REMOVE HOOD LOCK ASSEMBLY (for LHD)


    1. A01W1DK

      Disconnect the connector.

    2. Disengage the clamp.

    3. A01W0AH

      Remove the 3 bolts.

    4. A01W251

      Disconnect the hood lock control cable assembly and remove the hood lock assembly.

  15. REMOVE HOOD LOCK ASSEMBLY (for RHD)


    1. A01VZFR

      Disconnect the connector.

    2. Disengage the clamp.

    3. A01W463

      Remove the 3 bolts.

    4. A01W537

      Disconnect the hood lock control cable assembly and remove the hood lock assembly.

  16. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)


    1. Using a screwdriver, disengage the 5 clamps and hood cable grommet as shown in the illustration.

      A01W31PE03
      Text in Illustration
      *1 Hood Lock Control Cable Assembly *2 Washer Hose
      *a Hood Cable Grommet - -

      Tech Tips

      Tape the screwdriver tip before use.

    2. Pull the hood lock control cable assembly from the engine compartment and remove it.

  17. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)


    1. Using a screwdriver, disengage the 4 clamps and hood cable grommet as shown in the illustration.

      A01W431E02
      Text in Illustration
      *1 Hood Lock Control Cable Assembly *2 Washer Hose
      *a Hood Cable Grommet - -

      Tech Tips

      Tape the screwdriver tip before use.

    2. Pull the hood lock control cable assembly from the engine compartment and remove it.