ION GENERATOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the ion generator sub-assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Disconnect cable from negative battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	for 8GR-FKS: Click here for V35A-FTS: Click here
	Memorize steering angle neutral point	LKA/LDA system	Click here
		Parking support brake system*
		Pre-collision system
		Adaptive high beam system
		Lighting system (EXT) Cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic view monitor system	Click here
	Initialize rear door sunshade system	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here
Steering sensor (Including removal and installation)	Steering angle neutral point	Parking support brake system	Click here
		Parking assist monitor system	Click here
		Panoramic view monitor system	Click here
	Steering angle setting	Parking assist monitor system	Click here
	Steering angle setting	Panoramic view monitor system	Click here

*: When performing learning using the GTS.
Click here Click here

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.

PROCEDURE

PRECAUTION

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- for 8GR-FKS:
  
  Click here
- for V35A-FTS:
  
  Click here
CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- If the airbag deploys for any reason, it may cause a serious accident.
Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Click here

REMOVE ION GENERATOR SUB-ASSEMBLY

for LHD:

	Screw
	Air duct
	Pull out direction

Remove the 2 screws.

Slide in the direction of the arrow shown in the illustration and pull out the ion generator sub-assembly with air duct sub-assembly.

	Screw
	Air duct
	Pull out direction

for RHD:

Remove the 2 screws.
Slide in the direction of the arrow shown in the illustration and pull out the ion generator sub-assembly with air duct sub-assembly.

Pull Directly Up

Detach the claw and remove the air duct sub-assembly from the ion generator assembly.