BACKUP BOOST CONVERTER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during eco run vehicle converter assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Battery terminal is disconnected/reconnected	Memorize steering angle neutral point	LKA/LDA System	Click here
		Intelligent clearance sonar system*1
		Pre-crash safety system
		Lighting system (EXT) Cornering lights
		Adaptive high beam system
	Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Parking assist monitor system (w/ Parallel parking assist function)	Click here
		Parking assist monitor system (w/o Parallel parking assist function)	Click here
		Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Reset back door close position	Power back door system	Click here
Front television camera assembly Front bumper assembly Radiator grille	Front television camera view adjustment	Panoramic view monitor system	Click here for Initialization Click here for Calibration
Front bumper assembly (w/ Intelligent clearance sonar system)	Ultrasonic sensor detection angle Ultrasonic sensor detection angle registration	Intelligent clearance sonar system	Click here

*1: When performing learning using the GTS.

Click here

PROCEDURE

PRECAUTION

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notices before proceeding with work.

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE FRONT BUMPER ASSEMBLY

Click here
REMOVE ECO RUN VEHICLE CONVERTER ASSEMBLY
1. *a Lock Lever
  
  Move the lock lever as shown in the illustration and disconnect the eco run vehicle converter assembly connector.
2. Remove the bolt, nut and eco run vehicle converter assembly.
REMOVE NO. 1 CONVERTER CONTROL BRACKET
1. Remove the 2 bolts and No. 1 converter control bracket from the eco run vehicle converter assembly.