AUDIO AND VISUAL SYSTEM(for 7 Inch Display) CD Sound Skips

CAUTION / NOTICE / HINT

Note


  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

    Click here

  • When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:


    • A communication malfunction DTC may be stored.

    • The radio receiver assembly may not operate normally.

PROCEDURE


  1. CHECK CD


    1. B004FKA

      Check that the CD is not deformed or cracked.

      OK
      CD is not cracked or deformed.
      Result
      Proceed to
      OK
      NG

    NG

    END (CD IS FAULTY)

    OK

  2. CHECK CD


    1. B004GBA

      Check the CD.

      OK
      The CD is clean.

      Note

      Do not use a conventional record cleaner or anti-static preservative.

      Tech Tips

      If dirt is on the CD surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.

      Result
      Proceed to
      OK
      NG

    NG

    CLEAN CD

    OK

  3. REPLACE CD AND RECHECK


    1. Replace the CD with a new or known good one and check that the malfunction disappears.

      OK
      Malfunction disappears.
      Result
      Proceed to
      OK
      NG

    OK

    END (CD WAS FAULTY)

    NG

  4. CHECK RADIO RECEIVER ASSEMBLY


    1. Check the radio receiver assembly installation condition.


      1. Check that the radio receiver assembly is properly installed.

        OK
        The radio receiver assembly is properly installed.
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE RADIO RECEIVER ASSEMBLY Click here

    NG

    REINSTALL RADIO RECEIVER ASSEMBLY