ТЕРМОСТАТ СНЯТИЕ

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the thermostat removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative when not Performed	Link
Battery terminal is disconnected/reconnected	Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Initialize servo motor	Air conditioning system	Click here
	Reset slide door close position	Power slide door system	Click here
	Reset back door close position	Power back door system	Click here

PROCEDURE

DRAIN ENGINE COOLANT

Click here
REMOVE GENERATOR ASSEMBLY

Click here
DISCONNECT NO. 2 RADIATOR HOSE

Click here
REMOVE WATER INLET
1. Remove the 2 nuts and water inlet.
REMOVE THERMOSTAT
1. Remove the thermostat from the water inlet housing.
2. Remove the gasket from the thermostat.