REAR DISC BRAKE PAD(for TMC Made) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • The following procedure is for the LH side.

  • Use the same procedure for the RH side and LH side.

PROCEDURE


  1. PRECAUTION

    Click here

  2. REMOVE REAR WHEEL

    Click here

  3. PERFORM REAR BRAKE PAD REPLACEMENT MODE

    Click here

  4. DRAIN BRAKE FLUID

    Note

    If brake fluid leaks onto any painted surface, immediately wash it off.

  5. REMOVE REAR DISC BRAKE PAD

    CAUTION:


    • B008M85

      After lifting up the rear disc brake cylinder assembly, secure it in place before performing any work on it.

    • The rear disc brake cylinder assembly could fall, pinching hands or fingers and causing injury.


    1. B008LBV

      Disconnect the No. 2 parking brake wire assembly connector from the parking brake actuator assembly.

    2. B008KEIC01
      *a Hold
      *b Turn

      Hold the rear disc brake cylinder slide pin, and remove the bolt.

    3. B008MI2

      Pull the rear disc brake cylinder assembly upward.

    4. Remove the 2 rear disc brake pads from the rear disc brake cylinder mounting.

  6. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT


    1. Remove the rear No. 1 disc brake anti-squeal shim and rear No. 2 disc brake anti-squeal shim from each rear disc brake pad.

    2. B008MCN

      Using a screwdriver, remove the rear disc brake pad wear indicator plate from each rear disc brake pad.