НАСОС СИСТЕМЫ ОХЛАЖДЕНИЯ СНЯТИЕ

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine water pump assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Battery terminal is disconnected/reconnected Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes) Stop and start system

Click here

Memorize steering angle neutral point Panoramic view monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Initialize servo motor Air conditioning system

Click here

Reset slide door close position Power slide door system

Click here

Reset back door close position Power back door system

Click here

PROCEDURE


  1. DRAIN ENGINE COOLANT

    Click here

  2. REMOVE GENERATOR ASSEMBLY

    Click here

  3. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY


    1. Type A:


      1. B006NCL

        Remove the dust cover from the V-ribbed belt tensioner assembly.

      2. B006NAUN01

        Using SST, remove the bolt and V-ribbed belt tensioner assembly from the water inlet housing.

        SST
        09961-00950
    2. B006P1HN01

      Type B:


      1. Using SST, remove the bolt and V-ribbed belt tensioner assembly from the water inlet housing.

        SST
        09961-00950

  4. REMOVE ENGINE WATER PUMP ASSEMBLY


    1. B006P4A

      Remove the 7 bolts, engine water pump assembly and water pump gasket.