FUEL MAIN VALVE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel main valve assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Battery terminal is disconnected/reconnected	Memorize steering angle neutral point	LKA/LDA System	Click here
		Pre-crash safety system
		Lighting system (EXT) Cornering lights
		Adaptive high beam system
	Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Parking Assist Monitor System (w/ Parallel Parking Assist Function)	Click here
		Parking Assist Monitor System (w/o Parallel Parking Assist Function)	Click here
		Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Reset back door close position	Power back door system	Click here

Note

Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembly of the fuel suction tube with pump and gauge assembly to be impossible as the tube is pressed into the fuel suction plate sub-assembly.
When replacing the fuel filter, replace it together with the fuel suction plate sub-assembly.

Tube

PROCEDURE

REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Click here
REMOVE FUEL SENDER GAUGE ASSEMBLY

Click here
REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY

Click here
REMOVE FUEL PUMP FILTER

Click here
REMOVE FUEL MAIN VALVE ASSEMBLY
1. Remove the fuel main valve assembly (for Low Pressure).
  1. Remove the clip from the fuel filter.
  2. *a Protective Tape
    
    Using a screwdriver with its tip wrapped with protective tape, remove the fuel main valve assembly from the fuel filter.
    
    Note
    
    Pull out the fuel main valve assembly carefully because the O-rings are firmly installed between the fuel main valve assembly and fuel filter.
    
    Do not damage the fuel filter.
  3. *1 O-ring
    
    Remove the 2 O-rings from the fuel main valve assembly.
2. Remove the fuel main valve assembly (for High Pressure).
  1. Remove the clip from the fuel filter.
  2. *a Protective Tape
    
    Using a screwdriver with its tip wrapped with protective tape, remove the fuel main valve assembly from the fuel filter.
    
    Note
    
    Pull out the fuel main valve assembly carefully because the O-rings are firmly installed between the fuel main valve assembly and fuel filter.
    
    Do not damage the fuel filter.
  3. *1 O-ring
    
    Remove the 2 O-rings from the fuel main valve assembly.