4WD CONTROL ECU(for RHD) INSTALLATION

PROCEDURE

1. INSTALL 4WD ECU ASSEMBLY

   
   

   1. Attach the 2 claws to install the 4WD ECU assembly.

2. INSTALL ECU INTEGRATION BOX RH

   
   

   1. Attach the clamp.

   2. Install the ECU integration box RH with the 2 nuts and bolt.

      Torque:

      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

   3. Connect the connectors.

   4. Attach the 2 clamps.

3. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

   Click here

4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

5. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

   Click here

6. INSTALL INSTRUMENT SIDE PANEL RH

   Click here

7. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH

   Click here

8. INSTALL UPPER REAR CONSOLE PANEL

   Click here

9. INSTALL CONSOLE ARMREST ASSEMBLY

   Click here

10. INSTALL COWL SIDE TRIM BOARD RH

    Click here

11. INSTALL DOOR SCUFF PLATE ASSEMBLY RH

    Click here

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here