LUGGAGE COMPARTMENT DOOR ADJUSTMENT

CAUTION / NOTICE / HINT

B00893PC01
*a Centering Bolt
*b Standard Bolt

Tech Tips


  • Centering bolts are used to mount the door hinge to the door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

  • Specified torque for standard bolts is shown in the standard bolt chart.

    Click here

PROCEDURE


  1. INSPECT LUGGAGE COMPARTMENT DOOR


    1. Check that the clearance measurements of areas a through d are within each standard range.

      B0083CVN01
      Standard Clearance
      Area Measurement Area Measurement
      a 5.8 mm (0.228 in.) b 2.6 to 5.6 mm (0.102 to 0.220 in.)
      c -1.4 to 1.6 mm (-0.0551 to 0.063 in.) d 4.0 to 8.0 mm (0.157 to 0.315 in.)

  2. REMOVE SPARE WHEEL COVER ASSEMBLY

    Click here

  3. REMOVE SPARE WHEEL COVER TRAY

    Click here

  4. REMOVE REAR FLOOR FINISH PLATE

    Click here

  5. REMOVE LUGGAGE COMPARTMENT DOOR COVER

    Click here

  6. REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER LH

    Click here

  7. REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER RH

    Click here

  8. ADJUST LUGGAGE COMPARTMENT DOOR


    1. B0086XX

      Loosen the 4 door side hinge bolts to adjust the door horizontally and vertically.

    2. Tighten the 4 bolts after adjustment.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }
    3. B0085G5

      Using a T40 "TORX" socket wrench, slightly loosen the 2 striker mounting screws.

    4. Using a brass bar and a hammer, hit the striker to adjust its position.

    5. Using a T40 "TORX" socket wrench, tighten the 2 striker mounting screws after adjustment.

      Torque:
      23 N*m  { 235 kgf*cm, 17 ft.*lbf }

  9. INSTALL LUGGAGE COMPARTMENT DOOR HINGE COVER LH

    Click here

  10. INSTALL LUGGAGE COMPARTMENT DOOR HINGE COVER RH

    Click here

  11. INSTALL LUGGAGE COMPARTMENT DOOR COVER

    Click here

  12. INSTALL REAR FLOOR FINISH PLATE

    Click here

  13. INSTALL SPARE WHEEL COVER TRAY

    Click here

  14. INSTALL SPARE WHEEL COVER ASSEMBLY

    Click here