FRONT BUMPER(for Sport Package) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front bumper assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative (-) battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	LKA/LDA system	Click here
		Parking support brake system*
		Pre-collision system
		Adaptive high beam system
		Lighting system (EXT) Cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic view monitor system	Click here
	Initialize rear door sunshade system	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here
Front bumper assembly (Including removal and installation)	Ultrasonic sensor detection angle Ultrasonic sensor detection angle registration	Parking support brake system	Click here
Front bumper assembly (Including removal and installation)	Front television camera view adjustment	Panoramic view monitor system	Click here
w/ Parking Support Brake System Ultrasonic sensor (Removal and installation)	Ultrasonic sensor detection angle Ultrasonic sensor detection angle registration	Parking support alert system Parking support brake system	Click here
Front television camera assembly (Removal and installation) Radiator grille (Including removal and installation)	Front television camera view adjustment	Panoramic view monitor system	Click here

*: When performing learning using the GTS.
Click here

Tech Tips

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

Click here

PROCEDURE

PRECAUTION

CAUTION:

Be sure to read precaution thoroughly before servicing.

Click here

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click here
CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative(-) battery terminal to disable the SRS system.
- If the airbag deploys for any reason, it may cause a serious accident.
Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE UPPER RADIATOR SUPPORT SEAL

Click here
REMOVE RADIATOR COVER PLATE

Click here
REMOVE LOWER RADIATOR AIR DEFLECTOR

Click here

REMOVE FRONT BUMPER ASSEMBLY

Remove the 3 bolts.
Remove the 4 clips.

Tech Tips

Use the same procedure for the RH and LH side.
*1 Front Bumper Seal Bracket

Remove the screw.

Tech Tips

Use the same procedure for the RH and LH side.
Remove the front bumper seal bracket.

Tech Tips

Use the same procedure for the RH and LH side.
Remove the 8 screws.
Disconnect the 2 connectors.
Protective Tape

Put protective tape around the front bumper assembly.

	Place hands here
	Remove in this Direction (1)
	Remove in this Direction (2)

Detach the claw and clip while pulling toward the outside of the vehicle and remove the front bumper assembly as shown in the illustration.

Tech Tips

Use the same procedure for the RH and LH side.

Remove in this Direction

Detach the claw and remove the front bumper assembly.
Disconnect the headlight cleaner hose.

Tech Tips

Prepare a container before performing the procedure.