NETWORK GATEWAY ECU INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU)


    1. B004GTX

      Insert the hole of the central gateway ECU (network gateway ECU) into the pin of the blower assembly.

    2. Install the 2 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    3. Connect the central gateway ECU (network gateway ECU) connector.

  2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  3. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  4. INSTALL FRONT NO. 2 CONSOLE BOX INSERT (for LHD)

    Click here

  5. INSTALL FRONT NO. 1 CONSOLE BOX INSERT (for RHD)

    Click here

  6. INSTALL INSTRUMENT PANEL FINISH PANEL END RH (for LHD)

    Click here

  7. INSTALL INSTRUMENT PANEL FINISH PANEL END LH (for RHD)

    Click here

  8. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here