PROCEDURES NECESSARY WHEN AUXILIARY BATTERY TERMINAL IS DISCONNECTED/RECONNECTED
Necessary Procedures | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
---|---|---|
Steering sensor zero point calibration | Lane Departure Alert System (w/ Steering Control) | |
Pre-collision System | ||
Correct the steering angle neutral point | Parking Assist Monitor System (w/o Parallel Parking Assist Function) |
Note
After the power switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal.
PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED
Replacement Part | Necessary Procedure | Effect / Inoperative Function when Necessary Procedures are not Performed | Link |
---|---|---|---|
ECM | Perform Vehicle Identification Number (VIN) or frame number registration | MIL comes on | |
|
Inspection after repair |
|
|
Millimeter wave radar sensor assembly | Adjust millimeter wave radar sensor assembly |
|
|
|
Adjust forward recognition camera |
|
|
|
|
|
Click here for Initialization Click here for Registration |
Skid control ECU assembly |
|
|
Click here for Initialization Click here for calibration |
|
|
||
Brake actuator assembly |
|
||
Yaw rate and acceleration sensor |
|
||
|
Perform rotation angle sensor initialization and torque sensor zero point calibration |
|
|
Power steering ECU assembly | Assist map writing |
|
|
Spiral cable with sensor sub-assembly |
|
Parking assist monitor system (w/o Parallel parking assist function) | Click here for Initialization Click here for Calibration |
Rear television camera assembly |
|
||
Suspension, tires, etc. | Rear television camera assembly optical axis (Back camera position setting) | ||
Blind spot monitor sensor | Blind spot monitor beam axis inspection | DTCs are output | |
Hybrid vehicle control ECU | ECU communication ID registration (Immobiliser system) |
|
See Service Bulletin for the registration method. |
|
Code registration (Immobiliser system) |
|
|
|
Initialization servo motor (Air conditioning system) | DTCs are output | |
|
Initialize power window control system |
|
|
|
Initialize sliding roof system |
|
|
Headlight leveling ECU assembly*1 |
|
Headlight leveling function | |
Headlight ECU sub-assembly LH*2 |
|
||
Rear height control sensor sub-assembly | Perform headlight leveling ECU assembly initialization*1 | ||
Perform headlight ECU sub-assembly LH initialization*2 |
*1: for Single Beam Headlight
*2: for Triple Beam Headlight