CAUTION / NOTICE / HINT
Tech Tips
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
PROCEDURE
INSTALL FRONT BUMPER ASSEMBLY
|
Install in this Direction |
Connect the headlight cleaner hose.
Attach the claw to temporarily install the front bumper assembly.
Note
Do not damage the front bumper assembly.
|
Install in this Direction |
Attach the guide, claw and clip to install the front bumper assembly as shown in the illustration.
Tech Tips
Use the same procedure for the RH and LH side.
Remove the protective tape.
Connect the 2 connectors
Install the 8 screws.
| *1 | Front Bumper Seal Bracket |
Install the front bumper seal bracket.
Tech Tips
Use the same procedure for the RH and LH side.
Install the screw.
Tech Tips
Use the same procedure for the RH and LH side.
Install the 4 clips.
Tech Tips
Use the same procedure for the RH and LH side.
Install the 3 bolts.
INSTALL LOWER RADIATOR AIR DEFLECTOR
INSTALL UPPER RADIATOR SUPPORT SEAL
INSTALL RADIATOR COVER PLATE
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 8GR-FKS:
for V35A-FTS:
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
PERFORM DIAGNOSTIC SYSTEM CHECK
CHECK SRS WARNING LIGHT
ADD WINDSHIELD WASHER FLUID
Add washer fluid to the washer jar.
ADJUST HEADLIGHT AIMING
ADJUST FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)
PERFORM CALIBRATION
w/ Parking Support Brake System: