HARD DISK DRIVE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during hard disk drive removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA System

Click here

Pre-crash safety system

Lighting system (EXT)


  • Cornering lights
Adaptive high beam system
Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Parking assist monitor system (w/ Parallel parking assist function)

Click here

Parking assist monitor system (w/o Parallel parking assist function)

Click here

Panoramic view monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Reset back door close position Power back door system

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

    Click here

  4. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT

    Click here

  6. REMOVE LOWER INSTRUMENT FINISH PANEL SUB

    Click here

  7. REMOVE RADIO RECEIVER ASSEMBLY WITH REGISTER

    Click here

  8. REMOVE NO. 2 RADIO BRACKET

    Click here

  9. REMOVE HARD DISK DRIVE


    1. B007XTS

      Remove the 3 screws and cover.

    2. B007YFWC01
      *a Protective Tape
      B007Z37 Remove in this Direction

      Using a screwdriver with its tip wrapped with protective tape, pull out the hard disk drive as shown in the illustration and remove it.