THROTTLE BODY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during throttle body with motor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Replacement of throttle body with motor assembly

  • Cleaning the deposits from the throttle body with motor assembly

 Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

CAUTION:

Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

B007Z4V

PROCEDURE


  1. DRAIN ENGINE COOLANT

    Click here

  2. REMOVE NO. 2 ENGINE UNDER COVER

    Click here

  3. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. B007WUW

      Disconnect the throttle body with motor assembly connector.

    2. B007YJL

      Disengage the engine wire clamp.

    3. Remove the bolt and wire harness clamp bracket from the No. 2 air tube.

    4. B007YZVC01
      *1 No. 1 Water By-pass Hose
      *2 No. 2 Water By-pass Hose

      Slide the 2 hose clamps and disconnect the No. 1 water by-pass hose and No. 2 water by-pass hose from the throttle body with motor assembly.

    5. B007XRT

      Remove the 8 bolts, No. 2 air tube and throttle body with motor assembly from the intercooler assembly and intake manifold.

  4. REMOVE THROTTLE BODY GASKET


    1. B007YDF

      Remove the throttle body gasket from the intake manifold.

    2. B007WTR

      Remove the throttle body gasket from the No. 2 air tube.

  5. REMOVE NO. 2 AIR TUBE GASKET


    1. B007Z90

      Remove the No. 2 air tube gasket from the intercooler assembly.