SLIDING ROOF HOUSING(for Sliding Roof) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during sliding roof glass sub-assembly, sliding roof housing sub-assembly, sliding roof drive gear sub-assembly or sliding roof drive cable sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA System

Click here

Pre-Crash Safety System

Lighting System (EXT)


  • Cornering lights
Adaptive High Beam System
Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Parking Assist Monitor System (w/ Parallel Parking Assist Function)

Click here

Parking Assist Monitor System (w/o Parallel Parking Assist Function)

Click here

Panoramic View Monitor System

Click here

Initialize back door lock Power door lock control system

Click here

Reset back door close position Power back door system

Click here


  • Sliding roof ECU (sliding roof drive gear assembly)

  • Sliding roof glass sub-assembly

  • Sliding roof drive cable sub-assembly

 Initialize Sliding Roof System

  • Auto operation function

  • Jam protection function

  • Key-off operation function

  • Key-linked function

  • Wireless transmitter-linked function

  • Sliding roof open warning function

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

B007WTA

Click here

PROCEDURE


  1. REMOVE SLIDING ROOF SIDE GARNISH LH


    1. A01VXI1

      Disengage the 2 claws to remove the sliding roof side garnish LH.

  2. REMOVE SLIDING ROOF SIDE GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  3. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY


    1. Move the sliding roof glass sub-assembly to the fully closed position.

    2. Using a T25 "TORX" socket wrench, remove the 4 screws and sliding roof glass sub-assembly.

      A01VY2Y

      Note

      To prevent the sliding roof glass sub-assembly and sliding roof drive gear sub-assembly from becoming misaligned, move the sliding roof glass sub-assembly (sliding roof drive cable sub-assembly) to the fully closed position before removing.

  4. REMOVE SLIDING ROOF WEATHERSTRIP


    1. A01VTKC

      Remove the sliding roof weatherstrip from the sliding roof panel sub-assembly.

  5. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

    Click here

  6. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  7. DISCONNECT SLIDING ROOF DRAIN HOSE


    1. A01VUDP

      for Clamp Type:


      1. Disengage the claw and disconnect the sliding roof drain hose.

        Tech Tips

        Use the same procedure for the other 3 sliding roof drain hoses.

    2. A01VVMR

      for Clip Type:


      1. Expand the clip and disconnect the sliding roof drain hose.

        Tech Tips

        Use the same procedure for the other 3 sliding roof drain hoses.

  8. REMOVE SLIDING ROOF HOUSING ASSEMBLY (for Type A)


    1. Remove the 4 bolts, 6 nuts and sliding roof housing assembly.

      B007ZZ6

  9. REMOVE SLIDING ROOF HOUSING ASSEMBLY (for Type B)


    1. Remove the 8 bolts, 6 nuts and sliding roof housing assembly.

      B007ZDQ