REAR SEAT RECLINING ADJUSTER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the No. 1 seat reclining adjuster assembly RH removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative (-) battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	LKA/LDA system	Click here
		Parking support brake system*
		Pre-collision system
		Adaptive high beam system
		Lighting system (EXT) cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic view monitor system	Click here
	Initialize rear door sunshade system	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here
No.1 seat reclining adjuster assembly RH (Including removal and installation)	Initialize position control ECU	Rear power seat control system	Click here

*: When performing learning using the GTS.
Click here Click here

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.

Note

If the rear seat cushion airbag assembly LH was deployed, replace the rear seat cushion panel LH, rear seat cushion pad and separate type rear seat cushion cover with the necessary parts in accordance with the extent of the collision damage.
If the rear seat airbag assembly LH was deployed, replace the rear seat sub panel sub-assembly LH, separate type rear seatback pad and separate type rear seatback cover with the necessary parts in accordance with the extent of the collision damage.
Replace any other damaged parts as necessary.

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.

PROCEDURE

REMOVE REAR SEAT ASSEMBLY

Click here
REMOVE NO. 1 SEAT RECLINING ADJUSTER ASSEMBLY RH
1. Disconnect the connector.
2. Remove the 4 nuts and No. 1 seat reclining adjuster assembly RH.