VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1413, C1414

DTC Code DTC Name
C1413 Front Speed Sensor RH Output Malfunction
C1414 Front Speed Sensor LH Output Malfunction

DESCRIPTION

Refer to DTCs C1401 and C1402 Click here.

DTC No. DTC Detection Condition Trouble Area

C1413

C1414

Either of the following is detected:


  1. An open in the sensor signal circuit of a malfunctioning area occurs 255 times or more.

  2. At a vehicle speed of 20 km/h (12 mph) or more, noise occurs in the sensor signals of a malfunctioning wheel 75 times or more within 5 seconds.

  3. At a vehicle speed of 10 km/h (6 mph) or more, noise occurs once per rotor rotation for 15 seconds or more.


  • Front speed sensor RH/LH

  • Front skid control rotor RH/LH

  • Sensor installation

  • Wire harness or connector

  • Skid control ECU (Brake actuator assembly)

Tech Tips


  • DTC C1413 is for the front speed sensor RH.

  • DTC C1414 is for the front speed sensor LH.

WIRING DIAGRAM

Refer to DTCs C1401 and C1402 Click here.

INSPECTION PROCEDURE

Note

When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information Click here.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MOMENTARY INTERRUPTION) Click here


    NG
    OK
  2. READ VALUE USING GTS (FRONT SPEED SENSOR) Click here


    NG
    OK
  3. RECONFIRM DTC


    1. Clear the DTCs Click here.

    2. Turn the ignition switch off.

    3. Start the engine.

    4. Perform a road test.

    5. Check if the same DTC is recorded Click here.

      Result
      Result Proceed to
      DTCs C1413 and C1414 are not output A
      DTCs C1413 and/or C1414 are output B

    B
    A
  4. CHECK FRONT SPEED SENSOR INSTALLATION Click here


    NG
    OK
  5. INSPECT FRONT SPEED SENSOR TIP Click here


    NG
    OK
  6. INSPECT FRONT SPEED SENSOR ROTOR Click here


    NG
    OK
  7. CHECK HARNESS AND CONNECTOR (BRAKE ACTUATOR ASSEMBLY - FRONT SPEED SENSOR)


    NG
    OK
  8. INSPECT BRAKE ACTUATOR ASSEMBLY (SENSOR OUTPUT) Click here


    NG
    OK