CAMSHAFT OIL CONTROL SOLENOID INSTALLATION

PROCEDURE


  1. INSTALL CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY


    1. B005PF3C03
      *1 O-ring

      Apply engine oil to a new O-ring and install it to the camshaft timing oil control solenoid assembly as shown in the illustration.

      Note

      Do not damage the O-ring.

    2. B005LL7C95
      *a Adhesive

      Apply adhesive to 2 or 3 threads of 2 new bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    3. B005PDGC02
      *a Torque Wrench Fulcrum Length
      *b 10 mm Union Nut Wrench

      Temporarily install the camshaft timing oil control solenoid assembly to the timing chain cover assembly with the 2 bolts.

      Note


      • If the camshaft timing oil control solenoid assembly has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or moved out of place when installing the camshaft timing oil control solenoid assembly.

    4. Tighten the bolt (A).

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    5. Using a 10 mm union nut wrench, tighten the bolt (B).

      Torque:
      Specified tightening torque
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using a 10 mm union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)):

        8.8 N*m (90 kgf*cm, 78 in.*lbf)

    6. Connect the camshaft timing oil control solenoid assembly connector.

  2. INSPECT FOR ENGINE OIL LEAK

    Click here