AIR FUEL RATIO SENSOR INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL AIR FUEL RATIO SENSOR

   

   *a	Torque Wrench Fulcrum Length

   Tech Tips

   Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

   
   

   • w/ Canister Pump Module:

     Click here

   • w/o Canister Pump Module:

     Click here

   
   

   1. Using SST, install the air fuel ratio sensor.

      SST

      09224-00011

      Torque
      Specified tightening torque
      44 N*m (449 kgf*cm, 32 ft.*lbf)

      Note

      Replace with a new part if it is dropped or if it receives a strong impact.

      Tech Tips

      
      

      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 37.7 N*m (384 kgf*cm, 28 ft.*lbf)

   2. Connect the air fuel ratio sensor connector.

   3. Attach the 2 wire harness clamps.

2. INSPECT FOR EXHAUST GAS LEAK

   Click here