SHIFT PADDLE SWITCH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission shift switch assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

for 8GR-FKS: Click here

for V35A-FTS: Click here

Memorize steering angle neutral point LKA/LDA system

Click here

Parking support brake system*
Pre-collision system
Adaptive high beam system

    Lighting system (EXT)

  • Cornering lights
Variable gear ratio steering system

Click here

Parking assist monitor system

Click here

Panoramic view monitor system

Click here

Initialize rear door sunshade system Rear door sunshade system

Click here

Initialize power trunk lid system Power trunk lid system

Click here

Parts between the steering wheel and tires have been removed/installed, replaced or adjusted Perform actuator angle neutral point calibration and initialization

  • Variable gear ratio steering system

  • Steering wheel off-center

  • DTCs are output

Click here

*: When performing learning using the GTS.
Click here Click here

PROCEDURE


  1. PRECAUTION

    Click here

  2. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  3. REMOVE STEERING PAD SWITCH ASSEMBLY

    Click here

  4. REMOVE TRANSMISSION SHIFT SWITCH ASSEMBLY


    1. B006EY1

      Remove the 2 screws and disconnect the 2 transmission shift switch assemblies.

    2. for transmission shift switch assembly LH Side:


      1. B006BZDC01
        *1 Transmission Shift Switch Assembly
        *2 No. 1 Switch Wire
        *a Protective Tape
        B006DHE Lift up vertically

        Using a screwdriver with its tipped wrapped with protective tape, detach the 2 claws and No. 1 switch wire from the guide and lift the transmission shift switch assembly perpendicular from the steering wheel assembly and disconnect it as shown in the illustration.

        Tech Tips

        Tape the screwdriver tip before use.

      2. B006GEY

        Disconnect the No. 1 switch wire connector and remove the transmission shift switch assembly.

    3. for transmission shift switch assembly RH Side:


      1. B006F6CC01
        *1 Transmission Shift Switch Assembly
        *2 No. 1 Switch Wire
        *a Protective Tape
        B006DHE Lift up vertically

        Using a screwdriver with its tipped wrapped with protective tape, detach the 2 claws and No. 1 switch wire from the guide and lift the transmission shift switch assembly perpendicular from the steering wheel assembly and disconnect it as shown in the illustration.

        Tech Tips

        Tape the screwdriver tip before use.

      2. B006AWT

        Disconnect the No. 1 switch wire connector and remove the transmission shift switch assembly.

  5. REMOVE NO. 1 SWITCH WIRE


    1. B006C3Z

      Disconnect the 2 guides and remove the No. 1 switch wire from the lower steering wheel boss cover.