STEERING ANGLE SENSOR

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during steering sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Battery terminal is disconnected/reconnected	Memorize steering angle neutral point	LKA/LDA System	Click here
		Intelligent clearance sonar system
		Pre-Crash Safety System
		Lighting System (EXT) Cornering lights
		Adaptive High Beam System
		Parking Assist Monitor System (w/ Parallel Parking Assist Function)	Click here
		Parking Assist Monitor System (w/o Parallel Parking Assist Function)	Click here
		Panoramic View Monitor System	Click here
	Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes)	Stop and start system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Reset back door close position	Power back door system	Click here
Replacement of steering sensor	Steering angle neutral point (Initialize parking assist monitor system) Steering angle setting	Parking assist monitor system (w/ Parallel Parking Assist Function)	Click here for Initialization Click here for Calibration
		Parking assist monitor system (w/o Parallel Parking Assist Function)	Click here for Initialization Click here for Calibration
	Steering angle neutral point (Initialize panoramic view monitor system)	Panoramic view monitor system	Click here for Initialization Click here for Calibration
	Steering angle neutral point (Initialize intelligent clearance sonar system)	Intelligent clearance sonar system LEXUS parking assist-sensor system (w/ Intelligent Clearance Sonar System)	Click here

CAUTION / NOTICE / HINT

Note

If both the spiral cable sub-assembly and the steering sensor are malfunctioning, replace them with a new spiral cable with sensor sub-assembly.

PROCEDURE

REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Click here
REMOVE STEERING SENSOR
1. Disengage the 6 claws and 2 pins, and remove the steering sensor from the spiral cable sub-assembly.
  
  Note
  
  Do not damage the claws and pins of the spiral cable sub-assembly.

STEERING ANGLE SENSOR REMOVAL