STOP LIGHT SWITCH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the stop light switch assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative (-) battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	LKA/LDA system	Click here
		Parking support brake system*
		Pre-collision system
		Adaptive high beam system
		Lighting system (EXT) Cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic View Monitor System	Click here
	Initialize Rear Door Sunshade System	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here

*: When performing learning using the GTS.
Click here Click here

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.

PROCEDURE

REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

Click here
PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click here

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click here
CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative(-) battery terminal to disable the SRS system.
- If the airbag deploys for any reason, it may cause a serious accident.
Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for LHD)

Click here
REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY (for RHD)

Click here
REMOVE STOP LIGHT SWITCH ASSEMBLY
1. for LHD:
  1. Remove the return spring.
  2. Disconnect the connector.
  3. Turn the stop light switch assembly counterclockwise and remove it.
2. for RHD:
  1. Disconnect the connector.
  2. Counterclockwise
    
    Turn the stop light switch assembly counterclockwise and remove it.
REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
1. Remove in this Direction
  
  for LHD:
  
  Detach the claw and remove the stop light switch mounting adjuster.
  
  Note
  
  The stop light switch mounting adjuster must not be reused.
2. Remove in this Direction
  
  for RHD:
  
  Detach the claw and remove the stop light switch mounting adjuster.
  
  Note
  
  The stop light switch mounting adjuster must not be reused.