TELEMATICS TRANSCEIVER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the telematics transceiver removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	LKA/LDA system	Click here
		Parking support brake system*
		Pre-collision system
		Adaptive high beam system
		Lighting system (EXT) Cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic view monitor system	Click here
	Initialize rear door sunshade system	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here
Telematics transceiver assembly	Register vehicle information	Emergency call service	Click here
Mobile phone battery	Reset mobilephone battery condition	Emergency call service	Click here

*: When performing learning using the GTS.
Click here Click here

PROCEDURE

PRECAUTION

CAUTION:

Be sure to read precaution thoroughly before servicing.

Click here

Note

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click here
CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
  
  Click here
- If the airbag deploys for any reason, it may cause a serious accident.
Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE INSTRUMENT SIDE PANEL LH

Click here
REMOVE INSTRUMENT SIDE PANEL RH

Click here
REMOVE LOWER NO. 1 INSTRUMENT PANEL PAD SUB-ASSEMBLY

Click here
REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Click here
REMOVE NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Click here
REMOVE INSTRUMENT PANEL SAFETY PAD INSERT SUB-ASSEMBLY

Click here
REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

Click here
REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH

Click here
REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

Click here
REMOVE GLOVE COMPARTMENT DOOR PAD PLATE

Click here
REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Click here

REMOVE TELEMATICS TRANSCEIVER

	Bolt
	Connector
	Nut

Remove the bolt and nut.

Detach the guide.
Disconnect the 3 connectors and remove the telematics transceiver.