REAR SEATBACK HEATER(for 60/40 Split Seat Type LH Side) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seatback heater removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA System

Click here

Intelligent Clearance Sonar System*1
Pre-crash Safety System

Lighting System (EXT)


  • Cornering lights
Adaptive High Beam System
Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and Start System

Click here

Memorize steering angle neutral point Parking Assist Monitor System (w/ Parallel Parking Assist Function)

Click here

Parking Assist Monitor System (w/o Parallel Parking Assist Function)

Click here

Panoramic View Monitor System

Click here

Initialize back door lock Power Door Lock Control System

Click here

Reset back door close position Power Back Door System

Click here

*1: When performing learning using the GTS.

Click here

CAUTION:


  • B007WTA

    Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the seat frame may injure your hands.

PROCEDURE


  1. REMOVE REAR SEAT ASSEMBLY LH (w/o Rear No. 2 Seat)

    Click here

  2. REMOVE REAR CENTER SEAT INNER BELT ASSEMBLY (w/o Rear No. 2 Seat)

    Click here

  3. REMOVE REAR SEAT COVER CAP LH (w/o Rear No. 2 Seat)

    for Manual Seat:

    Click here

  4. REMOVE NO. 1 RECLINING ADJUSTER RELEASE HANDLE LH (w/o Rear No. 2 Seat)

    for Manual Seat:

    Click here

  5. REMOVE POWER SEAT SWITCH ASSEMBLY (w/o Rear No. 2 Seat)

    for Power Seat:

    Click here

  6. DISCONNECT SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD (w/o Rear No. 2 Seat)

    Click here

  7. REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD (w/o Rear No. 2 Seat)

    Click here

  8. REMOVE REAR SEATBACK COVER LH (w/o Rear No. 2 Seat)

    Click here

  9. REMOVE REAR SEATBACK BOARD CARPET ASSEMBLY LH (w/o Rear No. 2 Seat)

    Click here

  10. REMOVE SEPARATE TYPE REAR SEATBACK COVER WITH PAD (w/o Rear No. 2 Seat)

    Click here

  11. REMOVE REAR SEATBACK HEATER (SEPARATE TYPE REAR SEATBACK COVER) (w/o Rear No. 2 Seat)


    1. B007ZZZ

      Remove the 11 hog rings and rear seatback heater (separate type rear seatback cover) from the separate type rear seatback pad.

  12. REMOVE REAR NO. 1 SEAT ASSEMBLY LH (w/ Rear No. 2 Seat)

    Click here

  13. REMOVE REAR SEAT COVER CAP LH (w/ Rear No. 2 Seat)

    Click here

  14. REMOVE NO. 1 RECLINING ADJUSTER RELEASE HANDLE LH (w/ Rear No. 2 Seat)

    Click here

  15. REMOVE REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY LH (w/ Rear No. 2 Seat)

    Click here

  16. REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD (w/ Rear No. 2 Seat)

    Click here

  17. REMOVE REAR SEATBACK COVER LH (w/ Rear No. 2 Seat)

    Click here

  18. REMOVE REAR SEATBACK BOARD CARPET ASSEMBLY LH (w/ Rear No. 2 Seat)

    Click here

  19. REMOVE REAR SEAT UPPER RECLINING COVER LH (w/ Rear No. 2 Seat)

    Click here

  20. REMOVE RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY LH (w/ Rear No. 2 Seat)

    Click here

  21. REMOVE SEPARATE TYPE REAR SEATBACK COVER WITH PAD (w/ Rear No. 2 Seat)

    Click here

  22. REMOVE REAR SEATBACK HEATER (SEPARATE TYPE REAR SEATBACK COVER) (w/ Rear No. 2 Seat)


    1. B007Z62C01
      B007ZL6 Fastener

      Disengage the 2 fasteners.

    2. B00801O

      Remove the 2 hog rings.

    3. B007WN6

      Remove the 11 hog rings and rear seatback heater (separate type rear seatback cover) from the separate type rear seatback pad.