REAR SEATBACK HEATER(for 60/40 Split Seat Type RH Side) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seatback heater removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA System

Click here

Intelligent Clearance Sonar System*1
Pre-crash Safety System

Lighting System (EXT)


  • Cornering lights
Adaptive High Beam System
Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and Start System

Click here

Memorize steering angle neutral point Parking Assist Monitor System (w/ Parallel Parking Assist Function)

Click here

Parking Assist Monitor System (w/o Parallel Parking Assist Function)

Click here

Panoramic View Monitor System

Click here

Initialize back door lock Power Door Lock Control System

Click here

Reset back door close position Power Back Door System

Click here

*1: When performing learning using the GTS.

Click here

CAUTION:


  • B007WTA

    Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the seat frame may injure your hands.

PROCEDURE


  1. REMOVE REAR SEAT ASSEMBLY RH (w/o Rear No. 2 Seat)

    Click here

  2. REMOVE REAR SEAT COVER CAP RH (w/o Rear No. 2 Seat)

    for Manual Seat:

    Click here

  3. REMOVE NO. 1 RECLINING ADJUSTER RELEASE HANDLE RH (w/o Rear No. 2 Seat)

    for Manual Seat:

    Click here

  4. REMOVE POWER SEAT SWITCH ASSEMBLY (w/o Rear No. 2 Seat)

    for Power Seat:

    Click here

  5. DISCONNECT SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD (w/o Rear No. 2 Seat)

    Click here

  6. REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD (w/o Rear No. 2 Seat)

    Click here

  7. REMOVE REAR SEATBACK COVER RH (w/o Rear No. 2 Seat)

    Click here

  8. REMOVE REAR SEATBACK BOARD CARPET ASSEMBLY RH (w/o Rear No. 2 Seat)

    Click here

  9. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (w/o Rear No. 2 Seat)

    Click here

  10. REMOVE SEAT BELT ANCHOR COVER CAP (w/o Rear No. 2 Seat)

    Click here

  11. REMOVE REAR SEAT SHOULDER BELT COVER (w/o Rear No. 2 Seat)

    Click here

  12. REMOVE SEPARATE TYPE REAR SEATBACK COVER WITH PAD (w/o Rear No. 2 Seat)

    Click here

  13. REMOVE REAR SEATBACK HEATER (SEPARATE TYPE REAR SEATBACK COVER) (w/o Rear No. 2 Seat)


    1. B007YJT

      for Manual Seat:


      1. Remove the 11 hog rings and rear seatback heater (separate type rear seatback cover) from the separate type rear seatback pad.

    2. for Power Seat:


      1. B007Z05

        Remove the hog ring.

      2. B007YJT

        Remove the 11 hog rings and rear seatback heater (separate type rear seatback cover) from the separate type rear seatback pad.

  14. REMOVE REAR NO. 1 SEAT ASSEMBLY RH (w/ Rear No. 2 Seat)

    Click here

  15. REMOVE REAR SEAT COVER CAP RH (w/ Rear No. 2 Seat)

    Click here

  16. REMOVE NO. 1 RECLINING ADJUSTER RELEASE HANDLE RH (w/ Rear No. 2 Seat)

    Click here

  17. REMOVE REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY RH (w/ Rear No. 2 Seat)

    Click here

  18. REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD (w/ Rear No. 2 Seat)

    Click here

  19. REMOVE REAR NO. 1 SEAT RECLINING ADJUSTER INSIDE COVER (w/ Rear No. 2 Seat)

    Click here

  20. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (w/ Rear No. 2 Seat)

    Click here

  21. REMOVE REAR SEATBACK COVER RH (w/ Rear No. 2 Seat)

    Click here

  22. REMOVE REAR SEATBACK BOARD CARPET ASSEMBLY RH (w/ Rear No. 2 Seat)

    Click here

  23. REMOVE REAR SEAT UPPER RECLINING COVER RH (w/ Rear No. 2 Seat)

    Click here

  24. REMOVE RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY RH (w/ Rear No. 2 Seat)

    Click here

  25. REMOVE SEAT BELT ANCHOR COVER CAP (w/ Rear No. 2 Seat)

    Click here

  26. REMOVE REAR SEAT SHOULDER BELT COVER (w/ Rear No. 2 Seat)

    Click here

  27. REMOVE SEPARATE TYPE REAR SEATBACK COVER WITH PAD (w/ Rear No. 2 Seat)

    Click here

  28. REMOVE REAR SEATBACK HEATER (SEPARATE TYPE REAR SEATBACK COVER) (w/ Rear No. 2 Seat)


    1. B007ZU1

      Remove the 2 hog rings.

    2. B007XGQ

      Remove the 11 hog rings and rear seatback heater (separate type rear seatback cover) from the separate type rear seatback pad.