CRUISE CONTROL MAIN SWITCH REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE LOWER NO. 3 STEERING WHEEL COVER


    1. A01E20GE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver wrapped with protective tape, detach the 2 claws and remove the lower No. 3 steering wheel cover.

      Tech Tips

      Protective tape the screwdriver tip before use.

  4. REMOVE LOWER NO. 2 STEERING WHEEL COVER


    1. A01DV23E01
      Text in Illustration
      *A w/o Cruise Control System
      *B w/ Cruise Control System
      *1 Protective Tape

      Using a screwdriver wrapped with protective tape, detach the 2 claws and remove the lower No. 2 steering wheel cover.

      Tech Tips

      Protective tape the screwdriver tip before use.

  5. REMOVE STEERING PAD


    1. A01DZ8KE01
      Text in Illustration
      *1 Screw Case

      Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.

    2. A01DW9M

      Pull out the steering pad from the steering wheel as shown in the illustration. Then support the steering pad with one hand.

      Note

      When removing the steering pad, do not pull the airbag wire harness.

    3. Disconnect the horn connector.

    4. Disconnect the connector and remove the steering pad.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

  6. REMOVE CRUISE CONTROL MAIN SWITCH


    1. A01E0T7

      Disconnect the connector.

    2. Remove the 2 screws.

    3. A01DZF2

      Remove the switch as shown in the illustration.