FRONT SEAT INNER BELT ASSEMBLY REMOVAL

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT SEAT ASSEMBLY (for Separate Seat Type)

    A01E1WHE01

    1. Using a moulding remover, detach the 2 claws and remove the outer seat track bracket cover.

  4. REMOVE FRONT SEAT ASSEMBLY (for Bench Seat Type)


    1. A01DW5OE01

      Pull the inner belts out from the bottom of the seat cushion.

    2. Remove the 4 bolts.

    3. w/ Occupant detection sensor:

      Disconnect the connector under the seat.

    4. Remove the seat.

      Note

      Be careful not to damage the vehicle body.

  5. REMOVE FRONT SEAT INNER BELT ASSEMBLY

    A01DYJUE01

    1. w/ Driver seat belt warning light:

      Detach the clamp.

    2. A01DZD8E01

      w/ Driver seat belt warning light:

      Detach the wire harness from the clamp.

    3. Remove the nut and seat belt.

    4. Remove the buckle cover.

  6. REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Separate Seat Type)

    A01DWW6E01

    1. w/ Passenger seat belt warning light:

      Detach the 2 clamps.

    2. w/ Passenger seat belt warning light:

      Disconnect the connector.

    3. A01DW1LE02

      Detach the wire harness from the clamp.

    4. Remove the nut and seat belt.

    5. Remove the buckle cover.

  7. REMOVE FRONT SEAT INNER W/ CENTER BELT ASSEMBLY RH (for Bench Seat Type)

    A01E28R

    1. Remove the nut and seat belt.

  8. REMOVE FRONT SEAT INNER W/ CENTER BELT ASSEMBLY LH (for Bench Seat Type)

    A01DVI3

    1. Remove the bolt and seat belt.