| DTC Code | DTC Name |
|---|---|
| B1630 | Curtain Shield Airbag Sensor (RH) |
| B1632 | Curtain Shield Airbag Sensor Lost Communication (RH) |
DESCRIPTION
The rear airbag sensor LH or RH consists of a lateral deceleration sensor, etc.
If the airbag ECU assembly receives signals from the lateral deceleration sensor, it determines whether the SRS should be activated.
DTC B1630 or B1632 is stored when a malfunction is detected in the rear airbag sensor LH or RH circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Test Mode / Check Mode |
|---|---|---|---|---|---|
| B1630 | Curtain Shield Airbag Sensor (RH) | Either condition is met:
|
|
Comes on | Not applicable |
| B1632 | Curtain Shield Airbag Sensor Lost Communication (RH) | Either condition is met:
|
|
Comes on | Not applicable |
WIRING DIAGRAM
| *a | Rear Airbag Sensor RH |
| *b | Door Side Airbag Sensor RH |
| *c | Side Airbag Sensor Assembly RH |
| *d | Airbag ECU Assembly |
CAUTION / NOTICE / HINT
Note
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.
PROCEDURE
CHECK DTC
Turn the engine switch on (IG), and wait for at least 60 seconds.
Clear the DTCs stored in memory.
Turn the engine switch off.
Turn the engine switch on (IG), and wait for at least 60 seconds.
Check for DTCs.
| Result | |||
|---|---|---|---|
|
Tech Tips
Codes other than DTC B1630 and B1632 may be output at this time, but they are not related to this check.
| DTC B1630 and B1632 are not output |
|
USE SIMULATION METHOD TO CHECK Click here |
| DTC B1630 or B1632 is output |
|
CHECK REAR AIRBAG SENSOR RH
| *1 | Rear Airbag Sensor LH |
| *2 | Airbag ECU Assembly |
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Interchange the rear airbag sensor RH with LH and connect the connectors to them.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the engine switch on (IG), and wait for at least 60 seconds.
Clear the DTCs stored in memory.
Turn the engine switch off.
Turn the engine switch on (IG), and wait for at least 60 seconds.
Check for DTCs.
| Result | ||||
|---|---|---|---|---|
|
Tech Tips
Codes other than DTC B1630, B1632, B1635 and B1637 may be output at this time, but they are not related to this check.
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Return the rear airbag sensor LH and RH to their original positions and connect the connectors to them.
| DTC B1635 or B1637 is output |
|
REPLACE REAR AIRBAG SENSOR RH Click here |
| DTC B1630 or B1632 is output |
|
REPLACE AIRBAG ECU ASSEMBLY Click here |
| DTC B1630, B1632, B1635 and B1637 are not output |
|
USE SIMULATION METHOD TO CHECK Click here |