LIGHTING SYSTEM(w/ Automatic Headlight Beam Level Control System), Diagnostic DTC:B2456

DTC Code DTC Name
B2456 Left Headlight ECU Variation Error

DESCRIPTION

This DTC is stored if the headlight ECU sub-assembly LH for another destination is installed.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
B2456 Left Headlight ECU Variation Error

    Detection condition:

  • The ignition switch is ON.


    Malfunction status:

  • Vehicle specification information received via CAN communication is continuously mismatched


    Malfunction duration:

  • -

  • ECM

  • Main body ECU (multiplex network body ECU)

  • Headlight ECU sub-assembly LH

 Headlight ECU sub-assembly LH

CAUTION / NOTICE / HINT

Note


  • If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.

    Click here

  • The vehicle battery supplies power to the main body ECU (multiplex network body ECU) via the door control battery. Therefore, before performing this troubleshooting procedure, make sure to perform an on-vehicle inspection to confirm that the main body ECU (multiplex network body ECU) power source circuit is normal.*1

    Click here

  • Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.*2

  • Before replacing the ECM, refer to Service Bulletin.*2


    • *1: w/ Door Control Battery

    • *2: w/ Smart Entry and Start System

PROCEDURE


  1. CLEAR DTC


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.

    5. Clear the DTCs.


      Body Electrical > HL AutoLeveling > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT

  2. CHECK FOR DTC


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.

    5. Check for DTCs.


      Body Electrical > HL AutoLeveling > Trouble Codes
      OK
      DTC B2456 is not output.
      Result
      Proceed to
      OK
      NG

    OK

    USE SIMULATION METHOD TO CHECK Click here

    NG

  3. CHECK ECM


    1. Check if the part number of the ECM installed to the vehicle is correct.

      OK
      Part number is correct.
      Result
      Proceed to
      OK
      NG

    NG

    REPLACE ECM for 2AR-FE: Click here
    REPLACE ECM for A25A-FKS: Click here
    REPLACE ECM for 2GR-FKS: Click here

    OK

  4. CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)


    1. Check if the part number of the main body ECU (multiplex network body ECU) installed to the vehicle is correct.

      OK
      Part number is correct.
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH Click here

    NG

    REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here