REAR AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY LH


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Attach the guide and hold the side airbag sensor assembly LH in place.

    4. Install the nut.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the side airbag sensor assembly LH has been dropped, replace it with a new one.

      • When installing the side airbag sensor assembly LH, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Tighten the nut while holding the side airbag sensor assembly LH because the side airbag sensor assembly LH guide is easily damaged.

    5. Before connecting the airbag connector, check that the position of the housing lock is correct as shown in the illustration.

      B008J0YC07
      *a Correct *b Incorrect

    6. Connect the airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.


      1. While holding the CPA, be sure to engage the connectors until they are locked and check that the CPA is in its original position (when locking, make sure that a click sound can be heard).

        Note

        Do not push down the upper part of the CPA shown in the illustration when connecting the airbag connector.

        B008JF6C22
        *1 CPA - -
        *a CPA Upper Part - -

    7. Check that there is no looseness in the installation parts of the side airbag sensor assembly LH.

  2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

  3. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

    Click here

  4. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY

    Click here

  5. INSTALL ROPE HOOK ASSEMBLY

    Click here

  6. INSTALL UPPER DECK TRIM SIDE BOARD LH

    Click here

  7. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  8. INSTALL REAR FLOOR FINISH PLATE

    Click here

  9. INSTALL SPARE TIRE (w/ Spare Tire)

    Click here

  10. INSTALL REAR SEAT ASSEMBLY (for Manual Seat)

    Click here

  11. INSTALL REAR SEAT ASSEMBLY (for Power Seat)

    Click here

  12. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  13. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  14. CHECK SRS WARNING LIGHT

    Click here