TIRE PRESSURE WARNING SYSTEM TC and CG Terminal Circuit

DESCRIPTION

DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are indicated by the blinking of the tire pressure warning light.

WIRING DIAGRAM

A004J5HE03

PROCEDURE


  1. CHECK CAN COMMUNICATION SYSTEM


    1. Check if a CAN communication system DTC is output Click here.

      Result
      Result Proceed to
      DTCs are not output A
      DTCs are output B

    B
    A
  2. CHECK DTC (C2179/79)


    1. Check if DTC C2179/79 is output Click here.

      Result
      Result Proceed to
      DTC C2179/79 is not output. A
      DTC C2179/79 is output. B

    B
    A
  3. CHECK HARNESS AND CONNECTOR (TC of DLC3 - ECM)


    1. Disconnect the A34 ECM connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      D10-13 (TC) - A34-12 (WFSE) Always Below 1 Ω
      D10-13 (TC) - Body ground Always 10 kΩ or higher

    NG
    OK
  4. CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)


    1. A004K59E02
      Text in Illustration
      *1 Front view of DLC3

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      D10-4 (CG) - Body ground Always Below 1 Ω

    NG
    OK
  5. INSPECT DLC3 (TC VOLTAGE)


    1. A004JDNE02
      Text in Illustration
      *1 Front view of DLC3

      Connect the A34 ECM connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      D10-13 (TC) - D10-4 (CG) Ignition switch ON 11 to 14 V

    OK
    NG