THROTTLE BODY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

Perform "Inspection After Repairs" after replacing the throttle body with motor assembly.

Click here

PROCEDURE


  1. INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY

    Tech Tips

    Perform "Inspection After Repairs" after replacing the throttle body with motor assembly.

    Click here


    1. B005WC9C01
      *a Protrusion
      *b Groove

      Install a new gasket to the intake air surge tank assembly with the protrusion of the gasket oriented as shown in the illustration.

    2. Connect the water by-pass hose to the throttle body with motor assembly and slide the clip to secure the hose.

    3. Connect the No. 2 water by-pass hose to the throttle body with motor assembly and slide the clip to secure the hose.

    4. Install the throttle body with motor assembly to the intake air surge tank assembly with the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    5. Connect the throttle body with motor assembly connector.

  2. INSTALL AIR CLEANER WITH AIR CLEANER HOSE


    1. B005UG5C01
      *a Protrusion
      *b Groove

      Connect the air cleaner with air cleaner hose to the throttle body with motor assembly.

      Note

      Fit the protrusion on the air cleaner hose assembly into the hole of the hose clamp on the throttle body with motor assembly side.

    2. Insert the 3 air cleaner with air cleaner hose pins into the air cleaner support.

    3. Tighten the hose clamp.

      Torque:
      4.0 N*m  { 41 kgf*cm, 35 in.*lbf }

    4. Attach the clamp to the air cleaner with air cleaner hose.

    5. Attach the wire harness clamp.

    6. Connect the mass air flow meter sub-assembly connector.

  3. INSTALL NO. 1 AIR CLEANER INLET


    1. Install the No. 1 air cleaner inlet to the air cleaner with air cleaner hose and insert the pin into the air cleaner support.

  4. CONNECT NO. 2 PCV HOSE


    1. Connect the No. 2 PCV hose to the cylinder head cover sub-assembly and slide the clip to secure the hose.

  5. ADD ENGINE COOLANT

    Click here

  6. INSPECT FOR COOLANT LEAK

    Click here

  7. INSTALL RADIATOR SUPPORT TO CROSS MEMBER BRACE SUB-ASSEMBLY RH

    Click here

  8. INSTALL LOWER RADIATOR AIR DEFLECTOR

    Click here

  9. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here

  10. INSTALL RADIATOR COVER PLATE

    Click here

  11. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here