REAR DOOR SPEAKER REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   Note

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

3. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

   Click here

4. REMOVE REAR DOOR REGULATOR INSIDE HANDLE PLATE (w/o Power Window)

   Click here

5. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

   Click here

6. REMOVE DOOR ASSIST GRIP COVER LH

   Click here

7. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

   Click here

8. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

   Click here

9. REMOVE REAR NO. 1 SPEAKER ASSEMBLY

   
   

   1. Disconnect the speaker connector.

   2. 

      Using a drill bit with a diameter of less than 4 mm (0.157 in.), drill out the 3 rivet heads.

      CAUTION:

      Be careful as the cut rivet will be very hot.

      Note

      Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

   3. Continue drilling and push out the remaining rivet fragments.

   4. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.

      Note

      Do not touch the cone part of the speaker.

   5. Detach the claw and remove the speaker.

10. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 11 Speakers)

    
    

    1. 

       Detach the clamp.

    2. Remove the 2 screws and speaker.

       Note

       Do not touch the cone part of the speaker.