CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable some systems need to be initialized after the cable is reconnected Click here.
REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
Insert clip remover between the plate and trim board.
Turn the handle counterclockwise to remove the snap ring and handle.
REMOVE REAR DOOR REGULATOR INSIDE HANDLE PLATE (w/o Power Window)
Remove the inside handle plate.
REMOVE REAR DOOR NO. 1 STIFFENER CUSHION
Remove the stiffener cushion.
REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
Using moulding remover A, detach the 3 claws and remove the bezel plug.
REMOVE DOOR ASSIST GRIP COVER LH
Using moulding remover A, detach the 10 claws and remove the assist grip cover.
REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)
Using moulding remover A, detach the 6 claws and the clip.
Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
Remove the 3 screws.
Using a clip remover, detach the 8 clips.
*1 | w/ Rear Door Sunshade |
*2 | w/o Rear Door Sunshade |
Pull out the rear door trim board in the direction indicated by the arrow.
for 11 Speakers:
Disconnect the connector.
Disconnect the 2 cables from the inside handle.
REMOVE REAR CURTAIN SUB-ASSEMBLY LH (w/ Rear Door Sunshade)
Remove the 6 screws, detach the 2 claws and remove the curtain.
Remove the clip from the rear curtain sub-assembly.
REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 11 Speakers)
REMOVE REAR DOOR SPEAKER GRILLE SUB-ASSEMBLY (for 11 Speakers)
Detach the 3 claws and remove the rear door speaker grille sub-assembly.
REMOVE REAR NO. 1 SPEAKER ASSEMBLY
REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH
Remove the inner glass weatherstrip by pulling it upward in the direction indicated by the arrow in the illustration.
REMOVE REAR DOOR FRAME GARNISH LH
*1 | for Sedan: |
*2 | for Wagon: |
Detach the 2 clips.
Detach the claws and remove the rear door frame garnish.
REMOVE CURTAIN HOOK (w/ Rear Door Sunshade)
Remove the 2 screws and curtain hook.
Tech Tips
Use the same procedure for all curtain hooks.
REMOVE REAR DOOR SERVICE HOLE COVER LH
Disconnect connector and remove the service hole cover.
Tech Tips
Remove the remaining tape on the door.
REMOVE REAR DOOR GLASS RUN LH
*1 | for Sedan: |
*2 | for Wagon: |
Remove the rear door glass run.
REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
*1 | for Sedan: |
*2 | for Wagon: |
Remove the screw.
Remove the 2 bolts and rear door window division bar sub-assembly.
REMOVE REAR DOOR QUARTER WINDOW GLASS LH
*1 | for Sedan: |
*2 | for Wagon: |
Remove the rear door quarter window glass and rear door quarter window weatherstrip as a unit as shown in the illustration.
REMOVE REAR DOOR QUARTER WINDOW WEATHERSTRIP LH
*1 | for Sedan: |
*2 | for Wagon: |
Remove the rear door quarter window weatherstrip from the rear door quarter window glass.
REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
Remove the rear door glass sub-assembly from the rear door window regulator sub-assembly as shown in the illustration.
Note
Do not damage the door glass.
REMOVE REAR DOOR GLASS CHANNEL SUB-ASSEMBLY LH
Using a screwdriver, remove the glass channel.
Note
Be careful not to damage the glass.
REMOVE REAR DOOR GLASS CHANNEL FILLER
Remove the glass channel filler from the glass channel.
REMOVE REAR DOOR BELT MOULDING LH
for Sedan:
Remove the rear door belt moulding LH Click here.
for Wagon:
Remove the rear door belt moulding LH Click here.
REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY LH
w/ Power Window:
*1 | Temporary Bolt |
Disconnect the connector.
Loosen the temporary bolt.
Note
Do not remove the temporary bolt. If the temporary bolt is removed, the rear door window regulator may fall and cause damage.
Remove the 3 bolts.
Remove the rear door window regulator assembly.
Remove the temporary bolt from the rear door window regulator.
w/o Power Window:
Remove the 3 bolts and regulator.
Note
Be careful when removing the bolts as the regulator may fall and become damaged.
REMOVE REAR DOOR WITH MOTOR LOCK ASSEMBLY LH
REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
Using a screwdriver, detach the claw.
Tech Tips
Tape the screwdriver tip before use.
Remove the rear door remote control cable.
REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH
Using a screwdriver, detach the 3 claws.
Tech Tips
Tape the screwdriver tip before use.
*1 | w/o Double Locking System: |
*2 | w/ Double Locking System: |
Remove the rear door inside locking cable.
REMOVE REAR DOOR OUTSIDE HANDLE COVER LH
Using a T30 ''TORX'' socket, loosen the screw and detach the claw to remove the outside handle cover.
REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY LH
*1 | Holder |
Detach the holder as shown in the illustration.
Remove the handle by sliding and pulling it in the direction indicated by the arrow in the illustration.
REMOVE REAR DOOR FRONT OUTSIDE HANDLE PAD
Detach the 3 claws and remove the pad.
REMOVE REAR DOOR REAR OUTSIDE HANDLE PAD
Detach the 2 claws and remove the pad.
REMOVE REAR DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY LH
Using a T30 ''TORX'' socket, loosen the screw.
Slide the outside handle frame to remove it.
Tech Tips
Remove the outside handle frame through the service hole.
REMOVE REAR DOOR INSIDE PANEL REINFORCE SUB-ASSEMBLY LH
Remove the 4 bolts and rear door inside panel reinforce sub-assembly.
REMOVE NO. 2 SEPARATOR DOOR STIFFENER CUSHION
Remove the bolt and No. 2 separator door stiffener cushion.
REMOVE REAR DOOR CHECK ASSEMBLY LH
Remove the bolt, 2 nuts and door check.
Tech Tips
Remove the door check through the service hole.
Note
Be careful when removing the bolt and nuts as the door check may fall and become damaged.
REMOVE REAR DOOR WEATHERSTRIP LH
for Sedan:
Detach the 19 clips and guide, and remove the rear door weatherstrip.
Remove the double-sided tape.
for Wagon:
Detach the 18 clips and remove the rear door weatherstrip.
REMOVE REAR DOOR WINDOW FRAME MOULDING SUB-ASSEMBLY LH
REMOVE REAR DOOR MOULDING SUB-ASSEMBLY OUTSIDE LH (for Sedan)
REMOVE REAR DOOR UPPER WINDOW FRAME MOULDING LH (for Wagon)
REMOVE REAR DOOR REAR WINDOW FRAME MOULDING LH (for Wagon)
REMOVE REAR DOOR NO. 2 WEATHERSTRIP LH
Detach the 7 clips and remove the rear door No. 2 weatherstrip.