TRANSMISSION CONTROL CABLE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission control cable assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Memorize steering angle neutral point LKA/LDA System

Click here

Pre-crash safety system

Lighting system (EXT)


  • Cornering lights
Adaptive high beam system
Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Parking Assist Monitor System (w/ Parallel Parking Assist Function)

Click here

Parking Assist Monitor System (w/o Parallel Parking Assist Function)

Click here

Panoramic view monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Reset back door close position Power back door system

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. SECURE VEHICLE


    1. Fully apply the parking brake and chock a wheel.

      CAUTION:


      • Make sure to apply the parking brake and chock a wheel before performing this procedure.

      • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

      B00802W

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  5. REMOVE INLET AIR CLEANER ASSEMBLY

    Click here

  6. REMOVE BATTERY

    Click here

  7. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click here

  8. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

    Click here

  9. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  10. REMOVE CONSOLE BOX ASSEMBLY

    Click here

  11. REMOVE FRONT NO. 1 CONSOLE BOX INSERT

    Click here

  12. REMOVE FRONT NO. 2 CONSOLE BOX INSERT

    Click here

  13. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. B007Y1A

      Disconnect the transmission control cable assembly from the transmission floor shift assembly.

    3. B007XPF

      Disengage the 2 claws and disconnect the transmission control cable assembly from the transmission floor shift assembly.

    4. B007WQA

      Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.

    5. Using a screwdriver, disengage the 4 claws and disconnect the transmission control cable assembly with clip from the No. 1 transmission control cable bracket.

    6. B00801L

      Using a screwdriver, disengage the 2 claws and remove the clip from the transmission control cable assembly.

    7. B007XWZ

      Disengage the 2 clamps.

    8. B007ZUH

      Turn back the floor carpet.

    9. Remove the 3 bolts and the transmission control cable assembly from the cabin.