FUEL LID OPENER MOTOR ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel lid opener motor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA System

Click here

Intelligent clearance sonar system*1
Pre-crash Safety System

Lighting system (EXT)


  • Cornering lights
Adaptive high beam system
Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Parking assist monitor system (w/ Parallel parking assist function)

Click here

Parking assist monitor system (w/o Parallel parking assist function)

Click here

Panoramic view monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Reset back door close position Power back door system

Click here

*1: When performing learning using the GTS.

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

B007WTA

Click here

PROCEDURE


  1. REMOVE TONNEAU COVER ASSEMBLY (w/o Rear No. 2 Seat)

    Click here

  2. REMOVE DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat)

    Click here

  3. REMOVE REAR NO. 3 FLOOR BOARD (w/o Rear No. 2 Seat)

    Click here

  4. REMOVE SPARE WHEEL COVER (w/o Rear No. 2 Seat)

    for Compact Spare Tire:

    Click here

  5. REMOVE REAR DECK FLOOR BOX (w/o Rear No. 2 Seat)

    w/ Spare Tire:

    Click here

  6. REMOVE REAR FLOOR CARPET (w/o Rear No. 2 Seat)

    w/o Spare Tire:

    Click here

  7. REMOVE REAR NO. 4 FLOOR BOARD (w/o Rear No. 2 Seat)

    except Full Size Spare Tire:

    Click here

  8. REMOVE REAR NO. 4 FLOOR BOARD (w/o Rear No. 2 Seat)

    for Full Size Spare Tire:

    Click here

  9. REMOVE FRONT DECK FLOOR BOX (w/o Rear No. 2 Seat)

    w/ Spare Tire:

    Click here

  10. REMOVE DECK FLOOR BOX RH (w/o Rear No. 2 Seat)

    w/o Spare Tire:

    Click here

  11. REMOVE DECK FLOOR BOX LH (w/o Rear No. 2 Seat)

    w/o Spare Tire:

    Click here

  12. REMOVE DECK SIDE TRIM BOX RH (w/o Rear No. 2 Seat)

    except Full Size Spare Tire:

    Click here

  13. REMOVE DECK SIDE TRIM BOX RH (w/o Rear No. 2 Seat)

    for Full Size Spare Tire:

    Click here

  14. REMOVE REAR FLOOR FINISH PLATE (w/o Rear No. 2 Seat)

    Click here

  15. REMOVE REAR DOOR SCUFF PLATE LH (w/o Rear No. 2 Seat)

    Click here

  16. REMOVE REAR SEAT ASSEMBLY LH (w/o Rear No. 2 Seat)

    Click here

  17. REMOVE UPPER QUARTER TRIM PAD LH (w/o Rear No. 2 Seat)

    Click here

  18. REMOVE REAR SEAT SIDE GARNISH LH (w/o Rear No. 2 Seat)

    Click here

  19. REMOVE REAR FLOOR FINISH SIDE PLATE LH (w/o Rear No. 2 Seat)

    Click here

  20. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (w/o Rear No. 2 Seat)

    Click here

  21. REMOVE ROPE HOOK ASSEMBLY (w/o Rear No. 2 Seat)

    Click here

  22. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (w/o Rear No. 2 Seat)

    Click here

  23. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (w/o Rear No. 2 Seat)

    Click here

  24. REMOVE FUEL PUMP CONTROL ECU ASSEMBLY (w/o Rear No. 2 Seat)

    w/ Woofer, for 8AR-FTS:

    for Rear Heated Oxygen Sensor: Click here

    for Rear Air Fuel Ratio Sensor: Click here

    w/ Woofer, for 2GR-FKS:

    Click here

  25. REMOVE NO. 2 DECK BOARD REINFORCEMENT (w/o Rear No. 2 Seat)

    Click here

  26. REMOVE REAR NO. 1 SPEAKER BRACKET (w/o Rear No. 2 Seat)

    Click here

  27. REMOVE REAR NO. 3 SPEAKER ASSEMBLY (w/o Rear No. 2 Seat)

    Click here

  28. REMOVE REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat)

    Click here

  29. REMOVE REAR DOOR SCUFF PLATE LH (w/ Rear No. 2 Seat)

    Click here

  30. REMOVE REAR DOOR INSIDE SCUFF PLATE LH (w/ Rear No. 2 Seat)

    Click here

  31. REMOVE REAR SEAT OUTER TRACK BRACKET COVER LH (w/ Rear No. 2 Seat)

    Click here

  32. REMOVE FRONT DECK SIDE TRIM COVER LH (w/ Rear No. 2 Seat)

    Click here

  33. REMOVE REAR SEAT SIDE GARNISH LH (w/ Rear No. 2 Seat)

    Click here

  34. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (w/ Rear No. 2 Seat)

    Click here

  35. REMOVE ROPE HOOK ASSEMBLY (w/ Rear No. 2 Seat)

    Click here

  36. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (w/ Rear No. 2 Seat)

    Click here

  37. REMOVE NO. 2 AIR CONDITIONING CONTROL ASSEMBLY (w/ Rear No. 2 Seat)

    Click here

  38. REMOVE COOLER (NO. 2 ROOM TEMP. SENSOR) THERMISTOR (w/ Rear No. 2 Seat)

    Click here

  39. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (w/ Rear No. 2 Seat)

    Click here

  40. REMOVE FUEL LID LOCK WITH MOTOR ASSEMBLY


    1. B007X22

      Disengage the clamp.

    2. Disengage the claw.

    3. Disconnect the connector to remove the fuel lid lock with motor assembly.