VEHICLE STABILITY CONTROL SYSTEM TS and CG Terminal Circuit

DESCRIPTION

In Test Mode (Signal Check), a malfunction in the speed sensor that cannot be detected when the vehicle is stopped can be detected while driving.

Transition to the sensor check mode can be performed by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to ON.

WIRING DIAGRAM

*a	Skid Control ECU (Brake Actuator Assembly)

CAUTION / NOTICE / HINT

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (TS of DLC3 - BRAKE ACTUATORASSEMBLY)

   
   

   1. Disconnect the A84 skid control ECU (brake actuator assembly) connector.

   2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition D8-12 (TS) - A84-3 (TS) Always Below 1 Ω D8-12 (TS) or A84-3 (TS) - Body ground Always 10 kΩ or higher

   
   

   NG

   REPAIR OR REPLACE HARNESS OR CONNECTOR

   OK

2. CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)

   
   
   1. 

      Text in Illustration

      *a	Front view of DLC3

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition D8-4 (CG) - Body ground Always Below 1 Ω

   
   

   NG

   REPAIR OR REPLACE HARNESS OR CONNECTOR

   OK

3. CHECK HARNESS AND CONNECTOR (TS of DLC3 - BODY GROUND)

   
   
   1. 

      Text in Illustration

      *a	Front view of DLC3

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition D8-12 (TS) - Body ground Always 10 kΩ or higher

      Tech Tips

      If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step Click here.

   
   

   OK

   REPLACE BRAKE ACTUATOR ASSEMBLY Click here

   NG

   REPAIR OR REPLACE HARNESS OR CONNECTOR