STARTER(for 2.7 kW Type) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT FENDER SEAL LH


    1. Remove the 6 clips and front fender seal LH.

  4. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

  5. REMOVE NO. 2 ENGINE UNDER COVER

  6. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

    Click here

  7. REMOVE STARTER ASSEMBLY


    1. Remove the starter terminal cap.

    2. Disconnect the starter connector.

    3. A01WBK4

      Remove the nut and disconnect the starter wire.

    4. B0026CG

      Remove the bolt and disconnect the clutch flexible hose bracket.

    5. Remove the nut, starter assembly and disconnect the ground cable.