REAR CENTER SEAT OUTER BELT ASSEMBLY(for Power Seat) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSPECT REAR CENTER SEAT OUTER BELT ASSEMBLY

   Click here

2. INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY

   
   

   1. 

      Attach the guide and temporarily install the rear center seat outer belt assembly.

   2. Install the 2 bolts in the order shown in the illustration.

      Torque:

      Bolt A

      12.5 N*m  { 127 kgf*cm, 9 ft.*lbf }

      Bolt B

      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

3. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY

   
   

   1. Attach the guide in the installation direction shown in the illustration.

      

      Install in this Direction

      -

      -

   2. Pass the rear seat outer belt assembly LH, rear seat outer belt assembly RH and rear center seat outer belt assembly through the hole of the package tray trim panel assembly.

   3. Push in the installation direction to attach the clip.

      

      Install in this Direction

      -

      -

   4. Install the package tray trim panel assembly with the 2 clips.

4. INSTALL CENTER NO. 1 SPEAKER GRILLE SUB-ASSEMBLY

   Click here

5. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY LH

   Click here

6. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY RH

   Tech Tips

   Use the same procedure described for the LH side.

7. INSTALL PACKAGE TRAY TRIM SIDE COVER LH

   Click here

8. INSTALL PACKAGE TRAY TRIM SIDE COVER RH

   Tech Tips

   Use the same procedure described for the LH side.

9. INSTALL PACKAGE TRAY TRIM GARNISH LH

   Click here

10. INSTALL PACKAGE TRAY TRIM GARNISH RH

    Tech Tips

    Use the same procedure described for the LH side.

11. INSTALL ROOF SIDE RAIL GARNISH ASSEMBLY LH

    Click here

12. INSTALL ROOF SIDE RAIL GARNISH ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

13. INSTALL CENTER ROOM PARTITION GARNISH ASSEMBLY

    Click here

14. INSTALL ROOM PARTITION BOARD ASSEMBLY LH

    Click here

15. INSTALL ROOM PARTITION BOARD ASSEMBLY RH

    Click here

16. INSTALL REAR SEAT SIDE GARNISH LH

    Click here

17. INSTALL REAR SEAT SIDE GARNISH RH

    Tech Tips

    Use the same procedure described for the LH side.

18. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

19. INSTALL REAR DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure described for the LH side.

20. INSTALL REAR CENTER SEAT ARMREST ASSEMBLY

    Click here

21. INSTALL REAR SEATBACK ASSEMBLY LH

    Click here

22. INSTALL REAR SEATBACK ASSEMBLY RH

    Click here

23. INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY (FLOOR ANCHOR)

    
    
    1. 

       *a	Protruding Part

       Install the floor anchor of the rear center seat outer belt assembly with the nut.

       Torque:

       42 N*m  { 428 kgf*cm, 31 ft.*lbf }

       Note

       Do not allow the floor anchor part of the rear center seat outer belt assembly to overlap the protruding part.

    2. Check that the ELR locks.

       
       

       1. With the rear center seat outer belt assembly installed to the vehicle, check that the belt locks when it is pulled out quickly.

24. INSTALL REAR SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR)

    Click here

25. INSTALL REAR SEAT OUTER BELT ASSEMBLY RH (FLOOR ANCHOR)

    Tech Tips

    Use the same procedure described for the LH side.

26. INSTALL REAR SEAT CUSHION LOCK HOOK

    Click here

27. INSTALL REAR CENTER SEAT CUSHION ASSEMBLY

    Click here

28. INSTALL REAR SEAT CUSHION ASSEMBLY LH

    Click here

29. INSTALL REAR SEAT CUSHION ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

30. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

31. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

32. INSPECT SRS WARNING LIGHT

    Click here

33. INSPECT SEAT BELT WARNING SYSTEM

    Click here

34. INSPECT REAR SEAT ASSEMBLY

    Click here

35. INSPECT SEAT HEATER SYSTEM

    Click here

36. INSPECT CLIMATE CONTROL SEAT SYSTEM

    Click here

37. INSPECT SEAT VIBRATION SYSTEM (w/ Refresh Seat)

    Click here