VEHICLE STABILITY CONTROL SYSTEM TS and CG Terminal Circuit

DESCRIPTION

Sensor check mode can be entered by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to ON.

WIRING DIAGRAM

A01DZZNE34

INSPECTION PROCEDURE

Note


  • After replacing the brake actuator assembly, perform calibration Click here.

  • Before disconnecting the connector, make sure that there are no problems with the connection.

  • After disconnecting the connector, make sure that the connector case and terminals are not deformed or corroded.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3)


    1. Turn the ignition switch off.

    2. Disconnect the skid control ECU (brake actuator assembly) connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      S35-33 (TS) - D1-12 (TS) Always Below 1 Ω
      S35-33 (TS) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)


    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      D1-4 (CG) - Body ground Always Below 1 Ω
      Result
      Result Proceed to
      NG A
      OK for LHD B
      for RHD C

    B

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here

    C

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here

    A

    REPAIR OR REPLACE HARNESS OR CONNECTOR