HEATER BLOWER MOTOR RELAY REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

  4. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

  5. REMOVE NO. 1 HEATER RELAY

    A01E0Y9

    1. Remove the 2 nuts.

    2. Detach the clamp and disconnect the driver side junction block.

    3. A01DV1P

      Remove the No. 1 heater relay.